Item # item-2517, Refractory Anchor Studs on American Welding Services, Inc.

Portable Equipment Welding Equipment Arc & CD Studs Welding AccessoriesServicesBoiler Outage Services In-House Welding Welding & Fabrication

All Categories > Arc & CD Studs > Refractory Anchor Studs > Item # item-2517

Download PDF Print

Printable Page Email

Email This Page

Save To Favorites


	Item # item-2517, Refractory Anchor Studs

Download PDF

Email This Page

Save To Favorites

$Refractory$

larger image

Refractory Studs
Refractory Studs are used to secure single component castable or gunite linings of medium to heavy density material (up to 170lb. per cubic foot). Anchor studs are used on the lining of petroleum and petrochemical, towers, boilers, precipitators, heaters, stacks, breechings and in other situations where extreme temperature is not encountered. The use of these studs with one-shot linings is well established.
One leg of the anchor is shorter than the other to eliminate any shear plane failure tendencies common to higher density materials at elevated temperatures.
These studs are available in lengths up to 8.000” before weld length. After weld length is approximately 1/8” less than the before weld length.
Required Standard Accessories
Ferrule = 100101127
Chuck = 500015073
Grip/Foot = 501006018
Materials: Studs are available in Low Carbon Mild Steel and 18-8 Stainless Steel. Materials selection is dependent on anticipated service temperature range.

Specifications

Stud Diameter		0.250

Minimum Length		2.000

A		0.562

B		0.500

C		0.750

Item # item-2517, Refractory Anchor Studs

Stud Diameter

Minimum Length

A

B

C